How to Make Free Energy Water Pump – Ram Pump

How to make a hydraulic ram pump which requires no electricity and no motor.
NOTE : This pump uses falling water to lift a lesser amount of water to a higher elevation than the source. So, being primarily used for lifting relatively small amount of water to a higher elevation. if you want to deliver 2 cubic meter of water to an elevated location, you need at least 6 cubic meters of water to operate the pump 4 cubic meters of which will be used to drive the pump and goes directly as waste.

20 thoughts on “How to Make Free Energy Water Pump – Ram Pump”

  1. This Pump is a cyclic water pump powered by hydropower. It takes in water at one "hydraulic head" (pressure) and flow rate, and outputs water at a higher hydraulic head and lower flow rate.
    Applications:
    1. Pumping drinking water from streams that have significant slop.
    2. Lifting irrigation water from streams or raised irrigation channels.
    3.Lifting drinking water from springs to settlements on higher ground.

    Reply
  2. ไหลออกยังกะเยี่ยวแมว น้ำถังนึง ดึงมาใช้ ได้นิดเดียว ที่เหลือ ไหลออกมาทิ้ง เพื่อ????

    Reply

Leave a Reply to haris fadillah Cancel reply

four + seventeen =